Mr. Dsingh
i am sorry that my comments may have sounded a bit more harsh than intended, i do feel quite strongly about gunmaking as a craft.
let me a bit more precise.
in terms of the shot, the mechanism on a gun is only there for one thing. and that is to provide a breech which the piring pin runs through, so the firing pin can strike with enough force to ignite the primer(there the breech is there for several things but lets not get into them right now).
Now non firing can be because of:
faulty primers (contaminated with oil etc.)
Not enough force carried forward to the primer, which in turn can be:
weak, old or wrong springs for the hammer
poor design( wrong angel of firing pin, not enough sufficient lenght etc.)
faulty chambers (this i feel, will be the case with quite a few new production guns from india)
U may be right one must not be knowing much unless one has the experience I just shared the experience secondly mechanism is most important in each weapon each gun have some speific feature. Secondly as far as I have seen Jammu and Mandi gun makers have good skills . I rember one karrirudin or some by similiar name used to make very good guns ,even some small gun makers in region make standard guns . I have model of 2003 and 1976 and used elly ,mirage and Indian amno ,I never had any problem with these guns altough I have used midland, German guns apart from Bharat , Mehar Singh, Rajput GUNS but range of eagle gun is longer.
this is not possibly according to the laws of physics, so you are wrong on this, range is determined as i explained earlyer in this tread, this is actually the statment that got me fired up in the begining of this tread.
people in india has very few places to come for advice, and this place is the best as far as i can see, claming someones shotgun reaches further than another one is wrong and borderlining fraud, i give you the benefit of doubt as i belive that you say this out of lesser knowlegde, and not out of malice toward the future costumors that could belive you and be cheated in this way.
i dont think my credentials is a matter for discussion, so lets just say that i am an european gunmaker that produces shotguns and double rifles from C-classes to best guns, and i dare say that my knowlegde on this subject wildly surpasses both yours and the manufactors that you endorse so much, i hate to sound arrogant but this is a fact.
best
peter als nerving
Taksdale gun & rifle
Denmark