Disassembling & Reassembling Precihole Air Rifle

This is the place for discussing gun care, custom work, repairs and ask related technical questions.
Mona singh
Fresh on the boat
Fresh on the boat
Posts: 1
Joined: Wed Jul 25, 2018 5:15 am

Re: Disassembling & Reassembling Precihole Air Rifle

Post by Mona singh » Fri Jul 27, 2018 11:13 pm

Bro plz upload dissembling of nx 100 nitro piston air rifle

For Advertising mail webmaster
Sasho
Fresh on the boat
Fresh on the boat
Posts: 1
Joined: Wed Jun 23, 2021 5:55 am

Re: Disassembling & Reassembling Precihole Air Rifle

Post by Sasho » Wed Jun 23, 2021 6:09 am

Please help me how to remove the barrel of precihole px100 achilles

Rudransh
Almost at nirvana
Almost at nirvana
Posts: 131
Joined: Fri Dec 04, 2015 3:46 pm

Re: Disassembling & Reassembling Precihole Air Rifle

Post by Rudransh » Wed Jun 23, 2021 9:15 am

Mona singh wrote:
Fri Jul 27, 2018 11:13 pm
Bro plz upload dissembling of nx 100 nitro piston air rifle
Hello Mona
Remove scope if u have mount and see there are two small grub alien screws in that 11m m dovetail which can seen from top side see where barrel is pushed inside block(hope it doesn't sound bad)..remove those screws and simply u can pull out the barrel ..But first why u need to remove barrel?
Note: Before removing barrel u need to degas the gun remove the manomtr (just screw out) then loose the 8 clamp (which hold barrel and air tank) it also has three small screw which needs to loosened then proceed with barrel removing.

Hope this helped

Regards
Veerbhadra

ubaid
Fresh on the boat
Fresh on the boat
Posts: 5
Joined: Wed Dec 14, 2022 12:36 pm

Re: Disassembling & Reassembling Precihole Air Rifle

Post by ubaid » Wed Dec 14, 2022 4:03 pm

Thanks GNV for such a detailed post. It helped me a lot in understanding the trigger system.
I am using NX200.

Actually I have messed with my upper sear. As I was compressing I left the upper sear down after replacing the piston and compressed, which I could not and all the pressure came on the sear. This made the sear bend now the gun is not at all engaging (loading). And I am not able to remove the piston too. I can see the upper sear teeth blocking the piston even after lifting the sear completely up.

Your post gave an idea and the mistake I have done.
Please advise.
1. How to remove the piston.
2. Do I have to hold the upper sear up while Compressing and lower it only after fitting the piston lock?

Awaiting your response
Regards
Ubaid

Post Reply