Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
All posts related to air-guns (air-rifles, airsoft, air-pistols, air-guns etc.).
-
dev
- Old Timer
- Posts: 2587
- Joined: Wed Jun 14, 2006 5:16 pm
- Location: New Delhi
Post
by dev » Tue Aug 07, 2007 7:14 pm
Mack The Knife Bana";p="24625 wrote:In that case put a piece of tape (exactly one turn) on the part of the scope tube that aligns with the rear mount and put a couple of drops of Araldite (not a fast setting glue like Superglue) on the bottom part of the tape.
This should hold the scope in place and not mar the finish either.
Mack The Knife
I wish I had thought of the duct tape. But I use a fast glue to hold the araldite in place till it dries. A few dabs of locktite on the araldite works neatly.
Araldite works very well as it is shock proof. You can also remove it with hot water. Prolly not on a scope but other applications.
Regards,
Dev
To ride, to speak up, to shoot straight.
-
shahid
Post
by shahid » Sun Sep 09, 2007 11:14 am
THings are working fine now. Scope reset once again, no travel or creep noticed in about 50 rounds fired so far. Not getting enough time with this Toyota FJ cruiser launch and so on but will take it outdoors soon.
