Hello Friends.
Today, I had a free time so I decided I should work on my AR.
Finally,I mount scope,red dot site and some accessories on my AR and I like to shear pictures with all of you.
Here is my AR looks like before I mount anything on it.
All the accessories on my working table.
First I mount a picatinny rail on forehand for quick detach swivel.
After I mount this on my AR,my next step is mount rear and front flip-up sites.
After I mount sites on rail, my next step is to mount a FAB angled foregrip on forehand.
After I mount FAB angled foregrip,I decied that I should mount picatinny rail rubber guard on the rail so I won't feel any rail when I shoot my AR.
Now it's time to mount rings and scope on AR.
Here you guy's can see the rail on the forehand and DD upper rail are level.
After I mount sec.ring on the rail, i'll make sure both rings are level.
Now, it's time to mount 45 degree angle mount and red dot site. Reasons I mount this before the scope because, if I mount scope first then I can not tight red dot on the rail.
Now, it's time to mount scope.
Again I use scope bubble level to make sure my scope are level before i tight screws.
Also I use Vortex flip cap cover to protect my scope lens.
Here is the view through scope.In first picture you guy's can see a dot in the middle.
Here is the picture when that red dot is on(this is red dot scope).
Few other pictures.
Finally my AR-15 Project is complete. Now it's time to take this baby to the range.
More pictures and a video coming soon.
Enjoy.
Baljit