Dear Pravin,
This is my DIANA 460 magnum spring change project, I got the original piston seal but no main springs, but available with 350 magnum main spring , so finally cut few coils and reassembled, power is ok, now have a deep fear about loss of power in prolonged usage due to coil cuts.so never try this.
Here some pics for your ref.
http://i1259.photobucket.com/albums/ii5 ... dautz7.jpg
http://i1259.photobucket.com/albums/ii5 ... qd2np6.jpg
http://i1259.photobucket.com/albums/ii5 ... fiumvq.jpg
Diana 460 strip down-servcing
- Vishnu2017
- Almost at nirvana
- Posts: 166
- Joined: Thu May 11, 2017 9:55 am
- Location: COIMBATORE
- Contact:
Re: Diana 460 strip down-servcing
DECIDE, COMMIT, SUCCEED
-
- Almost at nirvana
- Posts: 186
- Joined: Tue May 01, 2018 12:35 am
Re: Diana 460 strip down-servcing
Hey Vishnu ,
Thanks for sharing ,I jave ordered breech seal an a titan spring ... Can you please confirm how much diameter your transfer port has ? 2mm or 4mm ? Do you have any restrictor plate ?
Mine is 2mm so power is roughly around 15fpe ... Am concerned about the shot cycle than power ... I will cut spring to 32 coils if it's more and assemble again with new breech seal ..
I also have ordered gsmith super spring let's see what suits best .
Cheers
Pravin
Thanks for sharing ,I jave ordered breech seal an a titan spring ... Can you please confirm how much diameter your transfer port has ? 2mm or 4mm ? Do you have any restrictor plate ?
Mine is 2mm so power is roughly around 15fpe ... Am concerned about the shot cycle than power ... I will cut spring to 32 coils if it's more and assemble again with new breech seal ..
I also have ordered gsmith super spring let's see what suits best .
Cheers
Pravin
-
- Fresh on the boat
- Posts: 7
- Joined: Sun Oct 03, 2021 10:47 pm
Re: Diana 460 strip down-servcing
Hello guys,
Bumping on an old thread, sorry for that. I just got a dyna magnum 460 and the retaining screw of the front sight is slipping. Any idea what is the size of the screw and if I can change the front sight? Where shall I order the part from?
Bumping on an old thread, sorry for that. I just got a dyna magnum 460 and the retaining screw of the front sight is slipping. Any idea what is the size of the screw and if I can change the front sight? Where shall I order the part from?
-
- Almost at nirvana
- Posts: 164
- Joined: Fri Jun 12, 2020 1:55 pm
Re: Diana 460 strip down-servcing
Check with Kiehberg . They may have spares for Diana.
-
- Fresh on the boat
- Posts: 7
- Joined: Sun Oct 03, 2021 10:47 pm
Re: Diana 460 strip down-servcing
No luck, any idea of other dealers for the front sight?